Make Additional Changes to the Local Area Connection Properties and Connect to PittNetġ. Uncheck the box next to Allow the computer to turn off this device to save power.ĥ. Note: The option in the Property field may be named Link Speed & Duplex or just Speed & Duplex.Ĥ. Click the Advanced tab and set the Ethernet card Speed & Duplex settings to 100 Mbps Full Duplex. Right-click on the Local Area Connection and then select Properties.ģ. You should still be in Network Connections. Note: Before beginning the steps in the rest of this document, unplug your Ethernet cable from your computer.ġ. Modify the Ethernet Card Speed and Power Management Below Connections, use the Up arrow to move the Local Area Connection to the top of the list.ħ. Select Advanced from the menu bar, then select Advanced Settings.Ħ. Press the Alt key to activate the menu bar.ĥ. Select Change adapter settings on the left-hand side of the window.Ĥ. Section 2 - Configure the Native 802.1x Client Set the Local Area Connection to be the Priority Connectionģ. Click on Start and wait for the service to start. Right-click on Wired AutoConfig and select Properties.Ħ. Note: In Control Panel, set View by: to Large Icons.Ĥ. This will search for and automatically open the Control Panel. From the Windows 8 Start screen, type Control Panel and then press the Enter key. Section 1 - Enable the Wired Auto Config ServiceĬonnect your computer to the network port with an Ethernet cable before you begin the steps below.ġ. Use the steps in Installing the InCommon and UserTrust Certificates (Windows). You must have administrative rights to your computer to complete these steps.īefore you manually configure your computer, be sure to install the required InCommon certificates. These connections may be located in classrooms, conference rooms, or other public areas. The 802.1x protocol is used for wired access to the University's network (PittNet) through publicly accessible network ports.
0 kommentar(er)
